3/8" M2 Chucking Reamer Drill Bit to Enlarge/Align Holes

About This

• [M2 HSS material]: Compared to other commonly used lower grade HSS, M2 has 50% more Tungsten and 150% more Molybdenum, both of which are key elements in improving the durability. It's suitable for FREQUENT use on mild steel or any softer material, and OCCASIONAL use on stainless steel. For frequent use on stainless steel, it's better to turn to our higher grade - M35 reamers.
• [Spiral Flutes & Safety stop]: Left Helix/Right Hand Cut sheers chips away from operator. Safety collar stop to prevent over penetration and operator loss of stability.
• [Tapered point]: Allow entry into overlapping holes.
• [Application]: Enlarge or align existing holes through mild steel, alloys, aluminum, wood, plastic, fiberglass or any similar hardness material prior to rivet or bolt installation. Commonly used in bridge, construction, steel erection/fabrication, and automotive (truck & trailer) industries. Up to 3/8"(10mm) thick mild steel for impact driver or 1" (25mm) thick for Magnetic drill press. Notice: it requires existing hole or a pilot hole would be needed.
• [Sizes]: 1 pieces, 3/8" (fit 3/8" shank chuck).

Overview

• Cutting Diameter : 9.53 millimeters
• Brand : Jerax tools
• Tool Flute Type : Spiral
• Surface Recommendation : Aluminum
• With decades of experience, we always choose the most approriate material along with proper treatment to make sure it does the job perfectly and at a low cost.
• We know what your pain points are and we take them seriously. We have a system of analyzing, prototyping, testing, and field using to make sure the problems are solved.
• Material is the foundation of a tool. Cheap material will not only be unable to finish the job but also cause extra work of trying and replacing. With decades of experience, we use the most approriate material along with proper treatment to make sure it does the job perfectly and at a low cost.
• We know what your pain points are and we take them seriously. We have a system of analyzing, prototyping, testing, and field using to make sure the problems are solved. No disruptive innovations but taking small steps improving existing proven designs. Our products may look similar to others in general but vary a lot in details and they outperform.
• Manufacturing conformance, Tolerance and Consistency are the three aspects we care most about. We make sure the products are made to our original design so they do the job as we want them to. We use proper processing so the tolerance is well controlled. And we have a quality control team and system to make sure every batch is the same quality.
• Compared to other commonly used lower grade HSS, M2 has 50% more Tungsten and 150% more Molybdenum, both of which are key elements in improving the durability.